Specification :
(length × width × height mm) 205*98*58-95*88cm
Ii. Material:
1. The bed body adopts double-layer stable structure, the bottom frame adopts ≥30×60×1.5mm rectangular steel pipe, and the upper frame adopts 3mm cold-rolled steel plate for overall stamping forming
2. Streamline ABS headboard and tail board (matching high and low), using pure engineering plastic, hollow molding, one-time blow molding, fade resistant, aging resistant, high strength, fall resistant and not easily broken. No health corner, easy to clean; Firm and firm; Hidden locking switch, stable and reliable, easy to disassemble, can also be used as CPR first aid function; Function: Back lift: 0-75 degrees
3, the use of "Denmark" imported motor performance is stable and reliable, no noise.
Bed board: engineering plastic bed board, leg board can be included under the back board to facilitate the function conversion between hospital bed and maternity bed.
4. Double-sided casters with central control, 5 inches in diameter; Left and right 1 round wheel combination; One-foot brake, four-wheel brake, double tie bar double safety structure, U-type brake pedal is made of aviation material flat pipe, stable and reliable; Built-in fully enclosed self-lubrication bearing, waterproof, dustproof, prevent clean cloth, hair and other foreign matters involved; The caster bracket, mounting seat and brake fork are made of aviation aluminum by one-time die-casting. The wheel surface is made of TPR wear-resistant material, which is mute and wear-resistant, can be washed and disinfected at high temperature, and will never rust.
5, guardrail: stainless steel turn-over guardrail, built-in spring, can be hidden in the guardrail under the bed board, convenient maternity seamless transfer.
6. The supporting arm of the bed transmission adopts the treatment of integral forming punching reinforcement to prevent the arm from deformation and damage;
7, bed body can withstand load ≥250㎏; Bed weight ≥ 120KG
8. There are two sockets for intravenous drips at the end of the head and the end of the bed. There is a socket for telescopic intravenous drips on both sides of the middle part of the bed with an aperture of 20mm, which is made of metal material and punched. Four drainage bag hooks are provided;
9. Stainless steel two-stage four-jaw drip rack, with a diameter of 19mm, is strong and durable
10. Function: Back lifting Angle: 0-75°±5°, legs can be hidden; Overall rise and fall 200MM, overall forward tilt 0-12°, overall backward tilt 0-5°.
